Chinese translation for "aging temperature"

老化温度

Related Translations:

ageing:  n.1.变陈；成熟；【化学】老化。2.【冶金】时效。

aged:  adj.1.老，老年的 (opp. young); 陈年的。 an aged man 老人。 the aged 老人，老者。 aged wine 陈年老酒。2.【物理学】被老化的。3.…岁的，(动物)达到几岁龄的〔通常，马7岁龄，牛3岁龄，猪2岁龄，羊1岁龄〕。短语和例子a man aged forty (years) 四十岁的人。n.-ness 老年，高龄。

aging:  短语和例子age 的现在分词。n.1.陈酿。2.熟化。

age:  n.1.年龄。2.成年〔满廿一岁〕。3.老年，晚年。4.寿命；终生，一生。5.时代，时期，年代。6.〔口语〕很长的时间 a man in his green old age 童颜老者。短语和例子full age 成年。 A- before honesty. 小孩必须礼让老人。 the age to come 后世。 of the age 现代的。 the present a

ages:  晚期糖基化终末化产物

age to age:  代代

age and ageing:  年龄与寿命

age age ratio:  年龄比

Example Sentences:

	1.	But the activation energy of water quenching samples are very different at different aging temperature , the lowest is 1 . 27ev and the highest is 2 . 4 lev 而水淬试样在不同的时效温度下激活能计算的结果有很大的不同，激活能最低为1 . 27ev ，最高为2 . 4lev 。
	2.	Furthermore , by integral method , all test data at different aging temperatures can be analyzed as an integration , so the prediction precision of storage life can be increased with the same specimens , or specimens can be saved in the same precision by this method 而且，固体推进剂贮存寿命整体预测方法能将各个老化温度下的固体推进剂试验数据作为一个整体进行统计分析，具有更大的信息量，可以提高寿命预测精度或节省大量试样。
	3.	The time taken to reach maximum hardness decreased and the corresponding maximum hardness decreased with increasing aging temperature . the better properties of al - mg - si - mn - cr alloy were obtained after 8h at 175 ' c . the al - mg - si - mn - cr alloy resembles al - mg - si alloy in the way of the age hardening mechanism 在同一温度下，随着时效时间的延长，合金硬度逐渐上升，在达到时效硬度峰值后又逐渐降低，随着时效温度的升高，中南大学硕士学位论文川mg st mn cr合金组织与性能的研究合金达到时效硬度峰值的时间缩短，而相应的时效硬度峰值在减小。
	4.	In this paper , 6013al / sicp / gr metal matrix composite ( mmc ) was produced by spray codeposition , by means of changing the medium of quenching , influence of five types of heat treatment system ( furnace cooling , air cooling , water quenching , dry ice quenching , liquid nitrogen quenching ) and different aging temperature on the damping was studied systematically 本文采用喷射共沉积方法制备了6013al sicp gr金属基复合材料( mmc ) ，通过改变淬火介质，较为系统地研究了五种热处理制度(炉冷、空冷、水冷、干冰冷及液氮冷)以及不同时效温度( 120 、 150 、 170 、 190及210 )对6013al sicp grmmc阻尼性能影响。
	5.	A reliability experiment of thermal aging was carried out for the two types of joints , scanning electron microscopy , energy dispersive x - ray spectrometer and micro x - ray diffractomer were adopted to investigate the interfacial evolution behavior of joints , and kinetics model of imc formation was established . the results show that imc growth follows the parabolic law as a function of aging time at certain aging temperature , imc growth is more sensitive to the aging temperature than the aging time , the activation energy of cu - al imc growth is 97 . 1kj / mol and the major forming cu - al imc are cual2 and cu9al4 , the activation energy of au - al imc growth is 40 . 1kj / mol and the main au - al imc are au4al and au5al2 , with au2al and aual at the interfacial periphery of joints , the rate of cu - al imc growth is about 1000 times slower than that of au - al imc , and kirkendall voids and cracks are easily appeared during thermal aging in gold ball bonds while voids and cracks are absent in copper ball bonds even after aging at 200 for 2900 hours and 250 for 169 hours 研究结果表明:金属间化合物厚度与老化时间的关系符合抛物线法则,金属间化合物的生长对老化温度比老化时间更加敏感; cu - al金属间化合物生长的激活能为97 . 1kj / mol ,老化后金属间化合物呈层状分布,主要相为cual2和cu9al4 ; au - al金属间化合物生长的激活能为40 . 1kj / mol ,主要相为au4al和au5al2 ,同时在界面周边区域生成了au2al和aual ;老化过程中cu - al金属间化合物生长速率比au - al金属间化合物生长速率小103数量级;金丝球键合点200老化96小时出现了明显的kirkendall空洞和裂纹,但铜丝球键合点200老化2900小时和250老化169小时都没有形成空洞和裂纹。
	6.	During the preparation process of the solid solution , a series of effect conditions were discussed such as ph value , si / h2o , the content of ligant , the surface active agent , the aging temperature , the drying means , the drier gel calcine and their effects on the gel quality , the process of sol - gel , the granular of powder and the density of the pellets , from which the best reaction condition was found 在制备过程中系统地研究了各种反应条件如ph值、 sal ； o 、络合剂的添加量、老化温度、干燥方式、干凝胶的锻烧方式等对溶胶“的质量、溶胶凝胶过程、粉体粒度及烧结体密度等的影响，确定了最佳反应条件：三、以li 。石i 。 。

Similar Words：

"aging stability" Chinese translation, "aging stage" Chinese translation, "aging steel" Chinese translation, "aging step" Chinese translation, "aging tank" Chinese translation, "aging test" Chinese translation, "aging tester" Chinese translation, "aging testing chamber" Chinese translation, "aging the account" Chinese translation, "aging the receivable" Chinese translation